Alloy Mode - DAK 900-EH Series Manual

3. ALLOY MODE

Preparation:
1. All mech. arrangements are as per solid mode.
2. Enter known densities of pure materials of alloy constituents in the "Alloy SG Set" option using
"Configuration Menu"
Configuration Menu  Alloy SG Set
- Press "Tare + Key A" till you enter into the "Configuration Mode" to set the SG values of the
constituents of which your test sample is composed of.
E.g.: For Alloy 2
- Press "A" & "Tare"
- Select the first option "Alloy SG Set" by pressing "Enter"
- Press "Tare + Key A" till you enter into the "Configuration Mode" to set the SG values of the
constituents of which your test sample is composed of.
- For entering the SG value of the constituents of the respective alloy number e.g. Alloy 2 use keys "A"
or "B" to values 2A, press enter on 2A
- Enter the SG for constituent 2A by using the Keys "A" or "B" to enter the required digit, note Key B
reduces the value in the descending order like 8,7,6 ... and by pressing Key A the digit value can be
increased like 5,6,7..To shift the digit cursors press "Tare" till to shift the cursor to the required digit,
which you wish to change. Follow similar procedure for entering values for Alloy 1 and 3.
- After entering values for 2A and 2B press "Enter" to continue
Measuring: -
Select alloy mode (1/2/3) in which the pure material densities are entered.
1. Follow all the steps as in solid mode
2. Density and Volume shall b displayed.
3. Press OK; Percentage of Main alloy material will be displayed.
4. Press OK, the data is sent to printer and PC.
__________________________________________________________________________________ 27