Solid Mode; Liquid Mode; Operating Instructions For Dak Densimeter - DAK 900-EH Series Manual

SOLID MODE: !

 Capable of measuring volume variation factor.
 Capable of indicating errors for the measured value.!
 Capable of setting measurement time at will.
 Capable of compensating water temperature at will: capable of compensating water temperature, required
for the measurement of the specific gravity!
 Capable of measuring plastic pellets!
 Capable of measuring readily floating samples, such as urethane rubber, plastics, sponge, and wood.

LIQUID MODE:

 Volume of sample needed for measurement is about 50cc.
 To measure different samples successively, just simply replace the beaker.
 A measurement result represents only value obtained through measurement at room temperature.
Operating Instruction for DAK Densimeter.
There are 5 keys for operating the Densimeter. They are as follows:
1. Power key – This key is used for Switch On & Switch Off purpose.
2. Key A – This key is used for "INCREASING" any numerical value such as time, date, temperature etc. This
key can also be used for moving "UP" in the menu option.
3. Key B – This key is used for "DECREASING" any numerical value such as time, date, temperature etc. This
key can also be used for moving "DOWN" in the menu option.
4. Tare – This is mainly used as Tare i.e. for setting the zero value before the test. It can also be used for
shifting the cursor or moving "BACK" from any menu option.
5. Enter – This key is used for approving the readings. This is also called as "OK" Key, it can also be used
__________________________________________________________________________________ 8