Table of Contents
Advertisement
Boiling Function
1. To prepare hot water, fill the tank with the
required amount of potable water.
2. Switch the function switch to ON position
(bottom position, Fig. 3).
The red operation indicator light will be on.
When the boiling point is reached, the heating element switches off automatically,
and the function switch is switched to OFF position (top position, Fig. 3). The red
operation indicator light goes off.
Water is not automatically kept warm at the reached temperature. To re-heat
water, the function switch must be re-set to ON position (bottom position, Fig. 3).
Beverage Dispensing
1. To dispense the prepared hot beverages, put a
EN
suitable container (glass, cup or mug)
underneath the drain tap.
2. Press the drain tap down and hold it pressed
until the required amount of liquid is dispensed.
Release the drain tap — it closes automatically.
ATTENTION!
Periodically check the liquid fill level, and re-
fill when required.
Never use the appliance without liquid!
14 / 16
Installation and operation
OFF
ON
Fig. 3
Fig. 4
200065
Advertisement
Table of Contents
