Table of Contents
Advertisement
Installation and operation
5. Put the lid on the tank, so that it catches on the tank handles by means of
rotating it.
WARNING!
Make sure that during operation no liquid pours out; otherwise, it might
cause shorting in the control electronics. This might result in bodily
injuries.
Observe the maximum filling volume!
Functions of the Appliance
The appliance features two functions:
– heating up function: for heating up liquids to approx. 80°C
– boiling function: for boiling water
Heating Up Function
1. Pour the required liquid (e.g., mulled wine,
punch, Jagertee, water) into the appliance
tank.
2. Make sure that the function switch is set to
OFF position (top position, Fig. 3).
3. Connect the appliance into a single grounded
outlet.
The red operation indicator light will be on.
4. Use the temperature controller and set the
temperature in the range of 30–80°C.
The liquid poured into the tank is heated up to the preset temperature.
NOTE!
The heating-up time is conditioned by the liquid and its amount.
When the preset temperature has been reached, the red operation indicator light
goes off, and the liquid is kept warm at the preset temperature.
When the temperature in the tank drops, the thermostat switches back on and the
liquid is re-heated up to the preset temperature, and the red operation indicator light
is on again.
5. Before re-filling with liquid, rotate the temperature controller counter-clockwise to
the position marked with ►.
6. Carefully remove the lid from the tank.
7. Pour the required amount of liquid.
200065
EN
Fig. 2
13 / 16
Advertisement
Table of Contents
