Figure 20. Installation On The Air Duct - Intel RS3P4TF160F Hardware User's Manual

Intel® RAID Adapters RS3P4TF160F and RS3P4MF088F Hardware User Guide
1. Power off the system and disconnect the power cables.
2. Remove the system top cover.
3. Remove the air duct
4. Remove the cable clip, if installed, by unfastening the two screws holding the clip to the chassis.
5. Align the two screw holes of the RMFBU mounting bracket with the matching threaded holes on the
base of the chassis or on the top of the air duct (see Letter A).
6. Secure the RMFBU mounting bracket to the chassis or to the air duct using two screws (see Letter B).
Tighten to 5 in-lb.
7. Slide the RMFBU assembly in the direction as indicated on the mounting bracket (see Letter C) until
the latch locks in place.
8. Attach all the connectors as required.
9. Reinstall the air duct.
10. Reinstall the system top cover.
11. Carefully route the extender cable to the Intel RAID adapter and attach the cable to the matching
connector. Use the appropriate cable (605 mm or 930 mm long) that best fits.

Figure 20. Installation on the Air Duct

41