Hitachi GR4000 Series Quick Start Manual page 70

GR4000 Quick Start Guide, Revision 1 - Preliminary
(3) Edit configuration information.
When changing an IP address and a line name, reset them after deleting their related parameters.
Deleting and reseting should be done in the following order.
deleting: routing protocol -> line name
reseting: line name -> IP address -> routing protocol
NOTE You can use the function of simplifying command inputs when setting configuration information.
For details, see the section "6.1 Convenient Functions".
rip
GR1(config)#
[rip]
delete interface 192.168.2.1
!!GR1(config)#
Are you sure? (y/n):
[rip]
!!GR1(config)# exit
!!GR1(config)# apply
!GR1(config)# delete line ethernet1/0
Are you sure? (y/n):
line LAN1 ethernet 1/0
!GR1(config)#
[line LAN1]
ip 192.168.2.3/24
!GR1(config)#
[line LAN1]
exit
!GR1(config)#
rip
!GR1(config)#
[rip]
!!GR1(config)# interface 192.168.2.3
[rip interface 192.168.2.3]
!!GR1(config)# exit
apply
!!GR1(config)#
!GR1(config)#
NOTE The mark "!" will be shown at the beginning of a prompt if you change configuration information.
However, you can delete this mark by saving configuration information you changed. Likely, the
mark "!!" will be shown at the beginning of a prompt if you input the command which does not
need to be applied for operations immediately. In such a case, you can apply your settings for
operations immediately by inputting the "apply" command, after wich the mark "!!" will be
changed to "!".
54
y
y
...Delete RIP setting for "ethernet1/0".
...Apply deleted RIP setting for operations.
...Delete "ethernet1/0".
...Define the Ethernet port
1/0 as "LAN1".
...Set an IP address for "LAN1".
...Set RIP for "LAN1".
...Apply
RIP setting for operations.
QSGGR4K00-10 5794047-1X