Hitachi GR4000 Series Quick Start Manual page 45

(5) Create a new user ID, and set a login password.
The default user ID "operator " does not have a login password set for it. Therefore, you must set a login password by
yourself according to the following instructions in order to prevent the degradation of security.
1．Reset the default user ID, and set a login password for it
2．Delete the default user ID "operator".
This section explains about the operation for the item "1" above. As for the operation for the item "2", see the section "(7)
Delete the default user ID 'operator'".
The example below explains how to reset the default user ID "operator" to the new one "newuser"and how to set a
login password.
adduser
#
Login name: newuser
********
Password:
Retype new password:
Add user'newuser'? (y/n):
#
NOTE You must use a password consisting of 6 to 128 texts including some figures/special characters.
You cannot use a password consisting of only alphabets.
(6) Execute Logout command.
Logout should be done according to the following procedure.
quit
#
> logout
BSDI BSD/OS 3.1
login:
QSGGR4K00-10 5794047-1X
********
y
GR4000 Quick Start Guide, Revision 1 - Preliminary
...Input "adduser" command.
...Input "newuser" as a new user ID.
...Set a login password for the new user
(The password you input will not be shown.)
...Input the same password again for confirmation.
...Get back to the mode of general users.
...Execute logout command.
"newuser".
ID
29