Hitachi GR4000 Series Quick Start Manual page 43

NOTE You can use the function of simplifying command inputs when setting configuration information.
For details, see the section "6.1 Convenient Functions".
NOTE The following message might be shown in case that the network interface board NE100-48T is
installed.
"The interface_mode parameter specified in the system configuration cannot be used
for the mounted NIF.Change the interface_mode parameter defined in the system
configuration."
If the message above is shown, you cannot use NE100-48T unless you set its interface mode,
which must be done in configuration information.
3.3.1 Startup of GR4000
The following "login" prompt is shown after GR4000 is started up.
BSDI BSD/OS 3.1
operator
login:
3.3.2 Setting of a time, user ID and password
This section describes about the procedures for logging into GR4000, setting a time and password of administrator,
and adding/deleting a user ID.
(1) Log into GR4000.
Log into GR4000 by inputting a user ID. The "operator" is a default user ID set at the time of initial system introduction. （This
default user ID does not have a login password set for it.）
BSDI BSD/OS 3.1
login: operator
All Rights Reserved,Copyright(C)2003,Hitachi,Ltd.
*** Welcome to this system ***
>
(2) Set an exact time.
The time set as a default is not accurate.
Therefore, you must reset it to the accurate one according to the instructions written in the example below.
Ex. Time setting
set calendar 0309021530
>
Tue Sep 2 15:30:00 2003
>
(3) Register yourself as an administrator of GR4000.
Register yourself as an administrator of GR4000.
QSGGR4K00-10 5794047-1X
...Input "operator" as a
...Input "operator" as a user ID.
...Input a date and time (Year/Month/Date/Hour/Minutes) in two-digit values.
...The time you set will be shown.
GR4000 Quick Start Guide, Revision 1 - Preliminary
user ID.
27