Updating Your 4-Port Print Server's Firmware - Keyspan 4-Port Print Server 1.3.1 User Manual

Restoring the default settings will cause the 4-Port Print Server (hardware) to restart.
Tech Note: Restoring to default settings will also set the 4-Port Print Server's UDP
port to 3842 and the Multicast address to 239.255.176.42. If you previously changed
your UDP port and/or Multicast address, remember to change the Keyspan Server
Utility application's Local UDP Port to 3842 and Multicast address to 239.255.176.42.
You may not be able to see your 4-Port Print Server if you fail to change your Local
UDP Port a nd/or Multicast address. To change the Local UDP Port, go to the Local
Settings tab and edit the UDP Port field.
IMPORTANT NOTE FOR FIREWALL USERS: If you've configured your firewall
to allow access to the 4-Port Print Server, remember to check your firewall's setting.
The 4-Port Print Server's IP address may have changed after restoring to default
settings.

Updating Your 4-Port Print Server's Firmware

The Keyspan 4-Port Print Server's firmware can be updated at any time via the Keyspan Server
Utility application.
To do this, select the Servers tab, select your 4-Port Print Server, and then click the Edit Server
Config. If your 4-Port Print Server requires new firmware, you will receive a pop-up window with
instructions on how to update the server's firmware.
This User Manual applies to the Keyspan 4-Port Print Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:4-Port Print Server - User Manual
Page 37