Kamoer KXP100 Quick Start Manual page 9

 Connect The Device To The Cloud
This device supports knob operation and remote control by mobile phone App. If you
want to control by mobile phone app, you need to configure the device to connect to
Wi-Fi network first.
1. The wireless router has been connected to the Internet, and the mobile phone is
connected to the 2.4G Wi-Fi hotspot of the wireless router (the device does not support
5G Wi-Fi and cannot use 5G Wi Fi hotspot).
2. Open the Kamoer Remote App, log in with the registered account, click the "+" icon in
the upper right corner, select "Add device", and select "KXP 100" in the list of supported
devices to add.
3. After inputting the Wi-Fi password, select the device as shown in the figure above by
operating the device knob to make the device enter the network configuration state,
and complete the network configuration according to the interface prompt.
4. If select configure network by router, the device will display Sta Setting, and switch to
By Router in the upper right corner of the corresponding mobile App interface. Click the
""Sat Setting..."is on display"Button to enter the configure network by router. Wait for
the network configuration to complete.
5. If you select configure network by AP, the device will display AP Setting, select
Connect by AP in the App interface of the corresponding mobile phone, and click the
""AP Setting..." is on display"button to enter configure network by AP. Complete the
network configuration according to the interface prompt.
8