Kamoer KXP100 Quick Start Manual page 5

f.Interval duration display: the interval duration of each cycle;
g.Rotation / flow rate display: "T & S" mode is the speed set for the current cycle; "L & V"
mode is the speed set for the current cycle.
 Calibration
a.calibrate: the title bar of the interface, when the cursor is on the title bar, press the
button, the device returns to the upper interface;
b.Rotation speed: set the rotation speed during calibration, you can rotate the cursor
to the rotation speed by rotating the button, press the button to enter the edit mode,
adjust the rotation speed by rotating the button, press the knob again to exit the speed
editing mode;
c.Calibration time: the calibration time is fixed at 60 seconds. When the cursor is on the
calibration time, press the button to start the calibration. When the 60-second
countdown is completed, the user enters the obtained liquid volume into the device to
complete the calibration;
d.Flow rate: the flow rate corresponding to the current speed. When the calibration is
completed, the user enters the obtained liquid volume to complete the calibration.
The specific calibration process is as follows:
Prepare a graduated cylinder, put the outlet pipe of the equipment into the graduated
cylinder, put the water into the water inlet, prepare for calibration;
4