Headland Assist; Headland Assist Settings; Setting The 'Headland Assist' Position - Goldacres G6 Crop Cruiser 2 Series Software Update

Software Update Supplement - G6 Crop Cruiser Series 2 Operators Manual
Graphic for Boom in level position (arrowheads illuminated
Grey).

Headland Assist

Headland assist display of the G-Hub Home
screen is improved for greater clarity &
functionality.
New graphics on the Home screen show
boom:
• 'Centre Height' and whether the boom
is in
• 'Headland' position or
• 'Field' position.
Graphic for Boom returning to 'Level' position (arrowheads
illuminated Green)
GA8701177 REV 2 SUPPLEMENT SEPT 2022
Graphic for Boom in 'Field' position.
More information is provided under 'G-Hub
Settings' (in this Supplement) to assist with
Setting-up and Diagnostic functions.
Graphic for Boom in 'Headland' position.
Activate the 'Headland Assist' & 'Return to Level' functions
(illuminate Green).

Headland Assist Settings

The G-Hub Display provides Headland
Assist Settings used to lift the boom to a
predetermined height when in Headland Assist
mode, then return to required spray height
when back in Field (Spray) mode.
The Low & High Set Points set the boom
height above the target when not using the
XRT option.
To Select 'Headland Assist':
Press the 'Headland Assist' touch button
to select the function.
The touch button displays Green when
selected & Grey when deselected.
To Select the 'Return to Level':
Press the 'Return to Level' touch button to
select the function.
The touch button displays Green when
selected & Grey when deselected.
Sensor values for the Headland Assist auto functions can be
set when the boom is folded out into position.
Setting the 'Headland Assist'
Position
Sensor values for the Headland Assist auto
functions can be set when the boom is folded
out into position.
To Set the 'Headland' Position:
1 Adjust the boom centre section to the
desired headland height, then position the
LH & RH boom tilt to the desired headland
height.
2 Press & hold the 'Cruise Master' push
button.
3 While holding the 'Cruise Master' push
button, press 'Dual tilt up' push button to
set the position, then release both push
buttons.
To Set the 'Field' Position:
1 Adjust the boom centre section to the
desired working height.
2 Press & hold the 'Cruise Master' push
button.
3 While holding the 'Cruise Master' push
button. press 'Dual Tilt Down' push button
to set the position, then release both push
buttons.
9