Table of Contents
Advertisement
Software Update Supplement - G6 Crop Cruiser Series 2 Operators Manual
6 To accelerate driving forwards or in
reverse, push Hand Throttle (Joystick)
forward.
The further forward the Hand Throttle
(Joystick) is pushed, the faster engine rpm
and Crop Cruiser speed.
As the vehicle speed increases, the
transmission will shift up gears as required.
If the operator's hand is removed from the
Hand Throttle (Joystick), the throttle will
hold its position and the Crop Cruiser will
maintain its speed.
7 To decelerate, pull the Hand Throttle
(Joystick) back toward the neutral gate.
The Crop Cruiser will decelerate and shift
down gears as speed is reduced.
GA8701177 REV 2 SUPPLEMENT SEPT 2022
8 The Brake pedal can be depressed at any
time to reduce speed or decelerate the
Crop Cruiser.
Use of the Brake pedal will reset the
throttle back to engine idle speed.
Pull the Hand Throttle (Joystick) back into
the neutral gate to reset it, then push the
Hand Throttle (Joystick) forward again
to resume to required engine and driving
speed.
9 To stop the Crop Cruiser, pull the throttle
back into the neutral gate and depress the
brake pedal until stopped.
10 Select Neutral on the Gear Selector.
11 Engage the Park Brake.
.
Green light indicator functional change & the Boom Master
switch is now a touch button
G-Hub Interface
Several changes improve the functionality and
G-Hub Home screen operator interfaces.
Home Screen
Functional changes to the G-Hub Home
screen include:
•
Green light on the top right corner of
the G-Hub displays:
-
Green = Connected & OK
-
Red
= Display not connected
•
External Buzzer sounds, momentarily,
when the PLC is turned On with the
key & is running OK
•
Boom Master Switch - the Boom
Master indicator has been changed
to a Touch Button switch allowing the
Green light indicator & 'RPM Raise' additions shown.
External Screen
The External display screen includes a Green
light on the top right corner of display:
•
Green = Connected & OK
•
Red = Display not connected
Other External screen changes include:
•
'RPM Raise'
•
'Increase' & 'Decrease' RPM touch
buttons to adjust engine RPM while at
the filling station
•
Added in the Warning/Settings page
•
'Density Factor' adjustment
7
Advertisement
Table of Contents
