Set The Scd Areas [Scd Area] - Panasonic WV-U2500 Series Operating Instructions Manual

2 Settings
SCD information addition
[Information addition]
Select "On" or "Off" to determine whether or not to add SCD information to superimposed image data.
•
Default: Off

2.6.6 Set the SCD areas [SCD area]

Set the areas to activate the SCD (scene change detection) function.
IMPORTANT
•
During change of setting in the setup menu, no alarm will be detected. After setup is complete, close
the setup menu.
1.
Set the SCD area by dragging the mouse on the screen.
→
The designated area will become the SCD area and the outline of white color will be displayed. The
"Status" will become "On".
2.
Adjust "Detection area" and "Detection sensitivity" selecting the pull-down menu.
Refer to page 102 for further information about the "Detection sensitivity" and "Detection area".
Change areas and the settings of "Detection area" and "Detection sensitivity" as necessary.
3.
Click the [Set] button after completing the settings.
IMPORTANT
•
The setting will not be applied unless the [Set] button is clicked.
4.
To invalidate the SCD area, click the [Set] button after selecting "Off" for "Status".
→
The outline of the invalidated SCD area will turn to a dotted line. When the SCD area is invalidated, no
alarm will occur even when a motion can be recognized in the area.
104 Operating Instructions