Table of Contents
Advertisement
IMPORTANT
•
The mask area may move out of alignment if the setting for "Image capture mode" of the [Image] tab,
or "Image rotation" of the [Basic] tab is changed after the mask area has been configured. Make sure
to check the mask area after changing the settings.
•
The mask area may move out of alignment when "Optical zoom" and "Extra optical zoom" is configured.
Make sure to check the mask area after configuring "Optical zoom" and "Extra optical zoom".
[WV-U2542L] [WV-U2532L] [WV-U1542L] [WV-U1532L] [WV-U2142L] [WV-U2132L] [WV-U1142]
[WV-U1132]
•
Configure mask area settings with a zoom ratio of x1.0 used for extra zoom. The mask area operatesin
the mask position of zoom ratio of x1.0 even after extra zoom settings. [WV-U2540L] [WV-U2530L]
[WV-U2140L] [WV-U2130L] [WV-U1130]
Note
•
When the [Reset] button is clicked, masking for all the masked areas will be canceled.
2.5.4.3 Adjust the zoom and focus [WV-U2542L] [WV-U2532L]
[WV-U1542L] [WV-U1532L] [WV-U2142L] [WV-U2132L] [WV-U1142]
[WV-U1132]
Click the [Setup>>] button of "Zoom/Focus adjustment" on the [Image/Privacy] tab of the "Image" page.
(®Page 72)
2 Settings
Operating Instructions
83
Advertisement
Table of Contents
