Table of Contents
Advertisement
2 Settings
[SD memory card format]
To format the SD memory card, click the [Execute] button.
Once you click the [Execute] button, the "Format" confirmation screen will be displayed.
If you click the [OK] button, the formatting will start.
Once the "Format" completion screen is displayed, press the
IMPORTANT
•
All data saved on the SD memory card will be deleted when the SD memory card is formatted.
•
Do not turn off the power of the camera during formatting.
[Next] button
If you select "Alarm", and click the [Next] button, the alarm setup menu will be displayed. (®page 42)
If you select "Schedule", and click the [Next] button, the schedule function type setup menu will be displayed.
(®page 46)
2.3.2.2 Alarm: Configure the VMD and the SCD (alarm setup menu)
The settings relating to actions when an alarm is detected can be configured in this section.
Alarm
[VMD alarm]
•
On: If the VMD area is not configured, the entire region is configured. To configure the VMD area, use the
[VMD area] tab on the "Alarm" page. (®page 100)
To set the period for when VMD will be used, set the schedule for VMD permission. (®page 155)
If the period is not set, VMD will be continuously active.
•
Off: Disables all VMD states.
•
Default: Off
[SCD alarm]
•
On: Enables the SCD function. To configure the SCD area, use the [SCD alarm] tab on the "Alarm" page.
(®page 102)
To set the period for when SCD will be used, set the schedule for SCD permission. (®page 155)
If the period is not set, SCD will be continuously active.
•
Off: Disables the SCD function.
•
Default: Off
[Alarm deactivation time]
Set the duration for which detection is not to be performed after an alarm has been detected. For example, by
using this function you can prevent mail from being sent too often when the E-mail notifications are configured
to be sent to cellular phones when an alarm is detected.
5 – 600 seconds
42
Operating Instructions
button.
Advertisement
Table of Contents
