Set The Vmd Areas [Vmd Area] - Panasonic i-PRO WV-SPN531 Operating Instructions Manual

•
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to be deleted. The outline of the selected area will be
deleted.
[Light detection control]
Select "On" or "Off" to determine whether or not to suspend video motion detection affected by brightness
change such by a dimming level control.
•
Default: Off
IMPORTANT
•
"Light detection control" may not work when brightness change is too small.
•
When "On" is selected for "Light detection control", the video motion detection may not be performed
even when detecting a subject moving over the whole screen.
[Area No. notification]
When "Panasonic alarm protocol notification >>" is clicked, the [Notification] tab of the "Alarm" page will be
displayed. (®page 135)
VMD information addition
[Information addition]
Select "On" or "Off" to determine whether or not to add VMD information to superimposed image data.
The VMD information can be searched by some of Panasonic network disk recorders. Refer to the operating
instructions of the connected devices for further information about the functions and settings.
•
Default: Off

13.5.1 Set the VMD areas [VMD area]

Set the areas to activate the VMD function.
IMPORTANT
•
When the settings are being configured on the setup menu, sometimes the VMD function may not work
correctly.
13 Configure the alarm settings [Alarm]
Operating Instructions 131