Installing The Mounting Bracket On A Mast Or Beam; Attaching The Mounting Bracket To A Metal Carrier - Fronius Symo 10.0-3 208-240 Installation Instructions Manual

3
Installing the
Mounting Brack-
et on a Mast or
Beam
Attaching the
NOTE!
mounting brack-
When mounted on metal supports, the inverter must not be exposed to rainwa-
et to a metal car-
ter or splashing water from the rear.
rier
Provide suitable rainwater protection or splash water protection.
The mounting bracket must be secured in at least four places.
For installation of the inverter on a
mast or beam, Fronius recommends
using the "Pole clamp" (order no.
SZ 2584.000) mast mounting kit from
Rittal GmbH.
The kit can be used to mount the in-
verter on round or rectangular masts
with the following diameters: Æ from
40 to 190 mm (round mast), ÿ from 50
to 150 mm (rectangular mast)
17