Call A Pattern; Set Linear Scan Limit - HIKVISION DS-7100HQHI-K1 Series User Manual

3.6.7 Call a Pattern

Follow the procedure to move the PTZ camera according to the predefined patterns.
Steps
1. Click on the quick settings toolbar of the PTZ camera's live view.
2. Click Pattern to configure pattern.
3. Select a pattern.
4. Click Call to start the pattern.
5. Optional: Click Stop to stop the pattern.

3.6.8 Set Linear Scan Limit

Linear Scan trigger a scan in the horizontal direction in the predefined range.
Before You Start
Make sure the connected IP camera supports the PTZ function and is properly connected.
Note
This function is supported only by certain models.
Steps
1. Click on the quick settings toolbar of the PTZ camera's live view.
2. Click directional buttons to wheel the camera to a location, and click Left Limit or Right Limit to
link the location to the corresponding limit.
Note
The speed dome linear scans from the left limit to the right limit, and you must set the left limit
on the left side of the right limit. Also, the angle from the left limit to the right limit must be not
greater than 180º.
Digital Video Recorder User Manual
Figure 3-20 Pattern Configuration
40