Troubleshooting Guide - Kenwood SIRIUS KTC-SR901 Instruction Manual

Troubleshooting Guide

If you use this for the first time, it may be difficult to receive signals in the
beginning. In such a case, leave the SIRIUS source ON for 3 minutes and turn it
OFF and ON.
What might appear to be a malfunction in your unit may just be the result of
slight misoperation or miswiring. Before calling service, first check the following
table for possible problems.
PROBLEM
The Sirius mode cannot
be selected.
Nothing happens when
the buttons are pressed.
No sound can be heard,
or the volume is low.
No broadcast can be
received.
The following messages are displayed when certain problems are occurring in
your system. Take the recommended actions.
ANTENNA ERROR / ANT ERR :
Antenna is not connected correctly.
]
Make sure the antenna is connected correctly and then turn OFF/ON of the SIRIUS
source or Control unit.
TUNER ERROR / TUNE ERR :
Broadcast cannot be received due to an error in this unit.
]
Turn OFF/ON of the SIRIUS source or Control unit, or press the reset button of
Control unit.
ESN ERROR / ESN ERR :
ESN (Electronic Serial Number) is not registered in this unit.
]
Consult your nearest service center.
POSSIBLE CAUSE
The Sirius connection wire is not
connected.
Connect the power supply of the Sirius
satellite radio tuner.
The PROTOCOL selection switch of the
changer switching unit "KCA-S210A" is
not set properly.
The changer switching unit "KCA-
S210A" is not connected properly.
The fuse has blown.
The computer chip in the unit is not
functioning normally.
The input/output wires or wiring
harness are connected incorrectly.
The Sirius antenna is not connected.
No subscription is established.
SOLUTION
Use the Sirius connection wire to
connect the control unit and the Sirius
satellite radio tuner.
Connect the battery wire and ground
wire to the Sirius satellite radio tuner.
Set the PROTOCOL selection switch to
"N" position.
Connect the KTC-SR901 to the terminal
labelled TO CHANGER 2. See the
section on "Connecting Wires to
Terminals".
After checking for short circuits in the
wires, replace the fuse with one having
the same rating.
Press the reset button on the Control
unit .
Reconnect the input/output wires and/or
the wiring harness correctly. See the
section on "Connecting Wires to
Terminals".
Connect it properly by referring to
"Connecting Wires to Terminals".
Subscribe to SIRIUS.
-
11
English