Table of Contents
Advertisement
Installation
■ Mounting the DAB Hideaway Unit
2CAUTION
• Install the DAB hideaway unit in a well-
ventilated location and do not place
objects on top of it.
• When installing to the car, the unit should
be securely fastened at a location that will
not interfere with driving.
• When making a hole in the chassis, check
that the gas tank, break pipe, wire
harness, or other part is not located on
the other side, and be careful not to cause
scratches.
• When attaching the mounting fittings
(Accessory2) to the DAB hideaway unit,
use only the supplied mounting screws
(Accessory3) (M4 x 8 mm). Use of
screws other than those supplied may
result in internal damage or insecure
mounting and is very dangerous.
• Installation using the self-tapping screws
Accessory2
DAB antenna cable
Accessory5
• Installation using the velcro tapes
28
Accessory4 (Ø5 × 20 mm)
Accessory3
(M4 × 8 mm)
Carpet
Board etc.
thickness: 20 mm or more
Accessory6
Carpet
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of
slight misoperation or miswiring. Before calling service, first check the following
table for possible problems.
PROBLEM
POSSIBLE CAUSE
The DAB mode cannot
The DAB connection cable is not
be selected.
connected.
The PROTOCOL selection switch of the
changer switching unit "KCA-S210A" is
not set properly.
The frequency is
The DAB antenna is not connected.
displayed, but no sound
can be heard.
The unit is outside the reception area.
Nothing happens when
The computer chip in the unit is not
the buttons are pressed.
functioning normally.
No sound can be heard,
The input/output cables or wiring
or the volume is low.
harness are connected incorrectly.
No switching to the
The language is set under the Language
Secondary with B and
Filter Select Mode function.
F group.
Specifications
Specifications subject to change without notice.
DAB tuner section
Frequency range (L Band) ........................................1452.960 MHz ~ 1490.624 MHz
Frequency range
(Band III) ..........................................174.928 MHz ~ 239.200 MHz
Usable sensitivity (L Band) ....................................................- 10 dBm ~ - 97.5 dBm
Usable sensitivity
(Band III)........................................................ 0 dBm ~ - 100 dBm
Mode ................................................................................................Mode I, II, III, IV
General
Operating voltage ..........................................................14.4 V (11 ~ 16 V allowable)
Current consumption ....................................................................................450 mA
Installation size (W × H × D) ........................................................143 × 45 × 105 mm
Weight:..............................................................................................................537 g
SOLUTION
Use the DAB connection cable to
connect the control unit and the DAB
hideaway tuner.
Set the PROTOCOL selection switch to
"N" position.
Connect it properly by referring to
"Connecting Cables to Terminals".
Try receiving after you have entered the
receiving area.
Press the reset button on the Control
unit .
Reconnect the input/output cables
and/or the wiring harness correctly. See
the section on "Connecting Cables to
Terminals".
Set the Language Filter to off or select
another language.
29
Advertisement
Table of Contents
