Table of Contents
Advertisement
If you use this for the first time, it may be difficult
to receive signals in the
beginning.
In such a case, leave the SIRIUS source ON for 3 minutes
and turn it
OFF and ON.
What might
appear to be a malfunction
in your unit may just be the result of
slight
misoperation
or miswiring.
Before calling service, first check the following
table for possible
problems.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The Sinus mode cannot
The SInus connectlon wrre IS not
Use the SInus connectlon wire to
be selected.
connected
connect the control unit and the Stnus
satellrte radro tuner.
Connect the power supply of the Sinus
Connect the battery wrre and ground
satelllte radio tuner.
wrre to the SInus satelltte radio tuner.
The PROTOCOL selectlon swatch of the
Set the PROTOCOL selectron swatch to
changer swltchlng
unit "KCA-SPlOA" IS
"N" posltlon.
not set properly
The changer switching
unrt "KCA-
S21 OA" IS not connected properly.
Connect the KTC-SRSOI to the terminal
labelled TO CHANGER 2. See the
sectron on "Connecting Wires to
Terminals".
The fuse has blown.
After checking for short clrcurts In the
wires, replace the fuse wrth one havrng
the same rating.
Nothlng happens when
The computer chip In the unrt IS not
Press the reset button on the Control
the buttons are pressed
functlonrng
normally.
unit
No sound can be heard,
The Input/output
wares or wlnng
Reconnect the Input/output
wares and/or
01 the volume IS low
Ihalness are connected Incorrectly.
the wlnng harness correctly. See the
i
sectron on "Connecting Wares to
Terminals".
No broadcast can be
received.
I
The SIII~S antenna IS not connected
No subscnotron
IS establrshed.
Connect It properly by referring to
"Connectrng Wares to Terminals".
Subscnbe to SIRIUS.
The following
messages
are displayed
when certain
problems
are occurring
in
your system.
Take the recommended
actions.
ANTENNA
ERROR/ANT
ERR :
Antenna IS not connected correctly.
&Make
sure the antenna IS connected correctly and then turn OFF/ON of the SIRIUS
source or Control unit.
TUNER ERROR / TUNE ERR :
Broadcast cannot be received due to an error In this unit.
13Turn OFF/ON of the SIRIUS source or Control unit, or press the reset button of
Control unit.
ESN ERROR / ESN ERR :
IJ
ESN (Electronic Serial Number) IS not registered In this urxt.
*Consult
your nearest service center.
English- 1 1
Advertisement
Table of Contents
