Table of Contents
Advertisement
The messages shown below display your
systems condition.
Troubleshooting Guide
What might appear to be a malfunction in your
unit may just be the result of slight misoperation
or miswiring. Before calling service, first check the
following table for possible problems.
Linking:
Although the Sub channel was selected, it is
under reading or has not been received.
D
The HD Radio mode cannot be selected.
..... The connection wire is not connected.
lSI"
Use the connection wire to connect the control
unit and the HD Radio tuner.
D
Nothing happens when the buttons are pressed.
..... The computer chip in the unit is not functioning
normally.
a"
Press the reset button on the Control/Controller
unit.
D
No sound can be heard, or the volume is low.
..... The input/output wires or wiring harness are
connected incorrectly.
.,... Reconnect the input/output wires and/or the
wiring harness correctly. See the section on
.......... _.' S .C;9T!
!!~.<;~J!!g_'!Y_iT_~~_ ~9_I~E!!!!
' : ' . 9
Is
>.
..... The preset broadcast station is not transmitting in
the mode that was set with <Receive Mode>.
.,... Please set <Receive Mode> to "Auto".
----------------------------------------------------- .
..... It switches between the Digital broadcasting and
Analog broadcasting too often.
lSI"
If the receiving condition is bad, <Receive
_____. .__
~Q9.f?.?
__
~~.9_l}!2.~~_.~f?_~_~9_~·!':n9.I.og"
.
..... In digital AM broadcasting, receive mode switches
between stereo and monaural too often.
-
Receiving condition is bad or unstable. Stereo is
chosen when receiving condition is good, and
it switches to monaural when the condition
becomes bad.
-",--fhe-sc;urc-e-mode-;;;;;s-charig-eci"or
the power switch
was turned on.
-
The monaural signals are received several
seconds after power-on or after FM tuning to an
HD Radio station.
D
Radio reception is poor.
..... The car antenna is not extended.
______
~
__
.F:~!ll_~_~~_9_r}~_~!!!!9_9.L!!_9_1J_!_~~_'!:'.ay
.
..... The antenna control wire is not connected.
~
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>.
--------------------------------
D
The tunE!r cannot be used by the Dual Zone
System .
..... The HD Radio source cannot be selected by the Dual
Zone System.
-
An internal source other than Tuner can be
selected.
HD# Off/ #CH Off/ OFF:
The Sub channel, which cannot be used,
was selected.
<Receive Mode> is set to "Analog";
therefore, the channel cannot be used.
¢
Set <Receive Mode> (page 4/ 9) to
"Auto" or "Digital".
~
~
In HD Radio mode, the display of Station Name or Song
title should be set up. The channel information cannot be
displayed in the Frequency display. (page 6/ 9)
English
I 13
Advertisement
Table of Contents
