Troubleshooting Guide - Kenwood KTC-HR200 - HD Radio Tuner Box Instruction Manual

Troubleshooting Guide
~
~
The messages shown below display your
systems condition.
In HD Radio mode, the display of Station Name or Song
title should be set up. The channel information cannot be
displayed in the Frequency display. (page En-6/8/11)
HD# Off/ #CH Off/ OFF:
The Sub channel, which cannot be used,
was selected.
<Receive Mode> is set to "Analog";
therefore, the channel cannot be used.
¢
Set <Receive Mode> (page En-5/1 0/13)
to "Auto" or "Digital".
Although the Sub channel was selected, it is
under reading or has not been received.
Linking:
What might appear to be a malfunction in your
unit may just be the result of slight misoperation
or miswiring. Before calling service, first check the
following table for possible problems.
o
The HD Radio mode cannot be selected.
ttl' The connection wire is not connected.
1&
Use the connection wire to connect the control
unit and the HD Radio tuner.
--------------------------------
o
Nothing happens when the buttons are pressed.
ttl' The computer chip in the unit is not functioning
normally.
1&
Press the reset button on the Control/Controller
unit.
o
No sound can be heard, or the volume is low.
ttl' The input/output wires or wiring harness are
connected incorrectly.
.... Reconnect the input/output wires and/or the
wiring harness correctly. See the section on
............:..
c;:.~r:t.r1.~S::! ~~.g .. '{1!!!~~. ~5?.I~!.~!~~ I s> .
ttl' The preset broadcast station is not transmitting in
the mode that was set with <Receive Mode>.
.... Please set <Receive Mode> to "Auto".
--------------------------------------------.----------
ttl' It switches between the Digital broadcasting and
Analog broadcasting too often.
1&
If the receiving condition is bad, <Receive
............
~5?g~?_.~.~5?~!s!.~~
..
~~.~.~<?~~f::.r1.~log"
ttl' In digital AM broadcasting, receive mode switches
between stereo and monaural too often.
1&
Receiving condition is bad or unstable. Stereo is
chosen when receiving condition is good, and
it switches
to
monaural when the condition
becomes bad
------------._----.--.
__
._._---------------------------
ttl' The source mode was changed or the power switch
was turned on.
1&
The monaural signals are received several
seconds after power·on or after FM tuning to an
HD Radio station.
--------------------------------
o
Radio reception is poor.
ttl' The car antenna is not extended.
1&
Pull the antenna out all the way.
·~··Tr)e·anter)na·c·o·n·t·rorwi·re·is··not·connected.
1&
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>.
--------------------------------
o
The tuner cannot be used by the Dual Zone
System.
ttl' The HD Radio source cannot be selected by the Dual
Zone System.
1&
An internal source other than Tuner can be
selected.
En-16
I KTC-HR200