Mounting Location; Installation Instructions; Dimensions Mm (Inch) - Vector TCI-W11 Series Manual
Wall mounted universal controller
Hide thumbs
Also See for TCI-W11 Series:
- Quick start manual (4 pages) ,
- Manual (18 pages) ,
- Overview (20 pages)
Table of Contents
Advertisement
Mounting Location
•
Install the controller on an easy accessible interior wall, approx. 1.5 m above the floor in an area of average
temperature.
•
Avoid direct sunlight or other heat sources, e.g. the area above radiators and heat emitting equipment.
•
Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
•
Location of mounting is less critical if external temperature sensors are used.
•
Ensure adequate air circulation to dissipate heat generated during operation.
•
Observe local regulations.
•
Do not mount in a wet or condensation prone environments.
Installation instructions
See TCI-W installation sheet no. 70-000539 (www.vectorcontrols.com).
Dimensions mm (inch)
Doc: 70-00-0158C, V2.0-20220523
Subject to alteration
TCI-W11, TCI-W22 Universal Controller
© Vector Controls GmbH, Switzerland
T
S
ECHNICAL
PECIFICATION
Page 4-22
Advertisement
Table of Contents
