Multitech MultiModem SocketModem MT9234 Series At Commands Reference Manual page 2

AT Commands Reference Guide for the MultiModem and SocketModem MT9234 Series
MT9234SMI
MT9234ZBA
MT9234ZBA-USB
MT9234MU
MT9234ZPX-UPCI
MT9234ZPX-PCIE
ISI9234PCIE
PN S000434H, Version H
Copyright
This publication may not be reproduced, in whole or in part, without prior expressed written permission
from Multi-Tech Systems, Inc. All rights reserved.
Multi-Tech Systems, Inc. makes no representations or warranty with respect to the contents hereof and
specifically disclaim any implied warranties of merchantability or fitness for any particular purpose.
Furthermore, Multi-Tech Systems, Inc. reserves the right to revise this publication and to make changes
from time to time in the content hereof without obligation of Multi-Tech Systems, Inc. to notify any person
or organization of such revisions or changes.
Revisions
Revision Level
E
F
G
H
Trademarks
Multi-Tech registered trademarks include the Multi-Tech logo, MultiModem, and SocketModem.
Technical Support
Please refer to the Copyright/Technical Support page in the product User Guide or Developer Guide.
World Headquarters
Multi-Tech Systems, Inc.
2205 Woodale Drive
Mounds View, MN 55112
Phone: 763-785-3500 or 800-328-9717
Fax: 763-785-9874
Internet Address: http://www.multitech.com
Multi-Tech Systems, Inc. AT Commands for the MultiModem & SocketModem MT9234 Series (S000434H)
Downloaded from Elcodis.com electronic components distributor
Copyright © 2007-2010, by Multi-Tech Systems, Inc.
Date Description
01/02/09 Added the Quick Connect Command $FC. Removed +VLS values 8-15
(only values 1-7 are supported).
04/28/09 Updated the "Country/Regional Code Configuration" chapter. Changed
the syntax for +GCI. Added a note to the following commands that they
do not with parallel, USB, PCI, PCIe:
%DC, %DT, %H, %S, $D, $EB, $LB, $RP, $SB, #P, #S, and all Callback
Security Commands.
02/04/10 $FC Quick Connect has changed values and default:
0 = No quick connect; 1 = Sets quick connect speed at 1200; 2 = Sets
quick connect speed at 2400; Default = 0.
Changed +GCI syntax to +GCI=
11/10/10 Added a note to &Z regarding Storing Dialing Location and Number for
Callback Security.
Added Fax Class 2.0 to +FCLASS.
Added the $RP? function to $RP.
Changed the description of #S Enter Setup Password.
Added Callback Security password to #S= Store Setup Password.
Under the section listing commands that change when in Voice Mode,
deleted commands A and I.
Changed the values in +VGR.
Changed the values in +VGT.
For +VSM, changed the <cml> values, added a Response section,
added the +VSM? default, and changed the example for AT+VSM=?
Copyright and Technical Support
2