Network Data Programming Summary; Brand-New Fusion Network; System Data; Numbering Plan Data - NEC NEAX 2400 IPX Manual

DATA PROGRAMMING

Network Data Programming Summary

1. Network Data Programming Summary
This section provides a summary of the data programming of Fusion systems.

1.1 Brand-new Fusion Network

To install the Fusion network as a brand-new system, follow the overall data programming procedure
below.
1.1.1

System Data

• Decide an NCN and LN on the network.
• Assign System Data for each node. Use the ASYDN command for the NCN and the ASYDL
command for all nodes. The system data includes the size of LDM, NDM, Fusion Point Code
(FPC), etc.
Note: The data becomes effective by executing "Non-Load Initial" after setting the FPC.
• Assign unit data using the AFMU command for each node that exists on the network. Note that the
AFMU command is available at NCN only.
• Assign Logical Route Numbers for all routes (external trunk) on the network using the ALRTN
command. Note that the ALRTN command is available at NCN only.
1.1.2

Numbering Plan Data

ANPDN → ASPAN (for NCN only): Assign numbering plan data for telephone number.
•
ANPDL → ASPAL (for NCN and LN): Assign numbering plan data for Service Codes, Trunk
•
Access Codes, etc., other than STN (physical station) and TELN.
ANPD → ASPA (for NCN and LN): Assign numbering plan data for Physical Station Number using
•
STN.
The Numbering Plan data for the LDM and/or NDM cannot use separate Tenant Numbers (TN), so be sure
Note:
to assign the following data on the ASYDL command.
• ASYDL command, SYS1, INDEX 800
b1 = 1 (ASPAL command tenant data table development on LDM = Common)
b2 = 1 (ANPDL command tenant data table development on LDM = Common)
1.1.3

Station Numbering

• Assign Telephone and/or Physical Station Numbers using the following command:
ALGNN → ALGSN: Assign telephone number on the network. (NCN only)
ASDT: Assign Physical Number for each node as required. (available for NCN and LN)
CHAPTER 5
Page 60
Revision 1.0
NDA-24299