Booms; Technical Information; Fixed Boom; Manual Boom - Hardi ZENIT A750 Instruction Book

Booms

Technical Information

The ZENIT equipment fitted with pneumatic kits can be attached to three different types of booms. Each one of
these booms can be adapted to several different spout combinations, depending on whether it is the pneumatic
or hydro-pneumatic air system.
B11 – Fixed boom
This type of boom is for treating one complete row. The spouts
are totally adjustable as far as height and inclination is concerned.
Loosen the screws on the spout supports and adapt the height
and width. In order to direct the spout to the area to be treated it
can be rotated.
The three available spraying systems can be used with this.
B20 – Manual boom
This type of boom is for treating four row sides or two complete
rows. The spouts are totally adaptable to the type of crop. Loo-
sen the screws on the spout supports and adapt the height and
width. In order to direct the spout to the area to be treated it can
be rotated.
The left- and right-hand booms can be opened and closed ma-
nually. With the lifting cylinder (if it is fitted) it is possible to raise or
lower the two booms at the same time.
B20 –Hydraulic boom
This type of boom is for treating four row sides or two complete
rows. The spouts are totally adaptable to the type of crop. Loo-
sen the screws on the spout supports and adapt the height and
width. In order to direct the spout to the area to be treated it can
be rotated.
The left- and right-hand booms can be opened and closed ma-
nually. With the lifting cylinder (if it is fitted) it is possible to comple-
tely raise or lower the two booms at the same time.
4 - Start up
4.7