Table of Contents
Advertisement
Quick Links
500MA/MAM Turbine Series
(for marine applications)
Fuel Filter/Water Separator
Instruction Part Number 15335 Rev G
Turbine Series fuel filter/water
separator protects the precision
components of your engine from
dirt, rust, algae, asphaltines,
varnishes and especially water,
which is prevalent in low distillate
fuels. Contaminants are removed
from fuel using the following
legendary three stage process:
Stage 1—Separation
Using the fuel flow, the stationary
turbine separates large solids and
free water through enchanced
centrifugal force.
Stage 2—Coalescing
Smaller water droplets and solids
coalesce on the conical baffle and
fall to the collection bowl.
Stage 3—Filtration
Engines will benefit from near
100% water separation and fuel
filtration with Racor's proprietary
Aquabloc
water repelling media.
®
The replaceable filters are
available in 2, 10, and 30 micron
ratings.
ABS/BV
Contact Information
Parker Hannifin Corporation
Racor Division
P.O. Box 3208
3400 Finch Road
Modesto, CA 95353
Phone 800 344 3286
209 521 7860
Fax
209 529 3278
Email racor@parker.com
Web
parker.com/racor
Advertisement
Table of Contents
Related Manuals for Parker Turbine 500MA
Summary of Contents for Parker Turbine 500MA
- Page 1 100% water separation and fuel Contact Information filtration with Racor’s proprietary Aquabloc water repelling media. ® The replaceable filters are Parker Hannifin Corporation available in 2, 10, and 30 micron Racor Division ratings. P.O. Box 3208 3400 Finch Road Modesto, CA 95353...
-
Page 2: Installation Diagram
Mounting Instructions (all models) 5.9 in. (15.0 cm) 3.6 in. (9.1 cm) 3/8 in. (1.0 cm) diameter clearance for fasteners Outlet Inlet 5.6 in. (14.2 cm) Install assembly within 10º of verticle ± 10º Installation Diagram Fuel tanks above filter Optional Bypass Installation and Operation head pressure should not exceed maximum PSI of filter. - Page 3 Installation Guidelines These customer supplied • W hen routing hose, avoid BEFORE Installing The Filter materials should be on hand surfaces that move, have sharp Assembly before beginning installation. edges, or get hot (such as • Obtain good ventilation and exhaust piping). • Shop Towels lighting.
-
Page 4: Filter Replacement
Filter Replacement All Applications Frequency of filter replacement is debris. Lubricate new gasket determined by the contamination and seal (supplied with new level of your fuel. Replace filter filter) with motor oil or diesel 1. Isolate the filter assembly with every 500 hours, every other oil fuel before installation. -
Page 5: Specifications
Specifications 500MA 500MAM Maximum Flow Rate: 60 GPH (227 LPH) 60 GPH (227 LPH) Port Size (SAE J1926) 3/4´´-16 UNF 3/4´´-16 UNF Service Clearance Above Assembly 5.0 in. (12.7 cm) 5.0 in. (12.7 cm) Below Assembly 2.0 in. (5.1 cm) 2.0 in. -
Page 6: Part List
Part List Parts/kits listed can be purchased from a Racor distributor. Go to parker.com/racor for a distributor near you. Part Number Description RK 11888 Brass T-handle RK23183 Stainless Steel T-handle (both kits include o-ring) RK15078-02 Lid (includes #3) 15005 Lid Gasket... - Page 7 RK 19492 (UL Listed Shut-off Valve Kit) The RK 19492 UL Listed Shut-off Valve Kit may be retrofitted to fit most Racor Marine Fuel Filter/Water Separators to simplify draining contaminants from the collection bowl. • S imple open/close valve for easy contaminant evacuation. • 1/4˝ NPT threads on Valve and Plug.
- Page 8 USAGE. specifications, designs, comparable new product or availability and pricing, are repair the defective product. subject to change by Parker This express warranty shall be Warning Hannifin Corporation and inapplicable to any product not its subsidiaries at any time...