Table of Contents
Advertisement
Procedure
1. Check the correct position of the plastic ring
2. Align the position of the motor shaft so that you can insert it in the shaft
to grease the shafts.
3. Apply adhesive (medium strength, e.g. Loctite 243) to the bolts 1505.
4. Fasten the motor using the bolts 1505 with the specified torque based on the table in Thread
sizes and tightening torques for fastening bolts (Page 27).
You have mounted the standard motor on the K4 or K5 adapter.
Table 4-5
Coupling size
Bolt 1505
Table 4-6
Coupling size
Bolt 1505
T
for 1505 in Nm
A
4.5.4
Mount the servomotor with parallel key to the KQ or K8 adapter
NOTICE
Damage to the bearing caused by excessive forces
Avoid axial forces when installing on the motor.
Note
Dimension z12 applies for standard assignment of the coupling. If a special assignment is
required, consult the appropriate special dimension drawing.
SIMOGEAR adapters for gearboxes - KS, K2, K3, K4, K5, KQ, KQS, K8, A, AZ
Operating Instructions, 05/2022, A5E37431501A/RS-AL
Adapter K4
63
71
M8
M8
Adapter K5
56
140
3/8"
3/8"
31
31
Ex-version gearboxes
Impacts can cause sparks.
Apply adhesive (medium strength, e.g. Loctite 243) to the grub screw 1564 and
bolts 1505.
Ex-version gearboxes
The flange-mounted motor must be sealed across the entire contact surface in order
to prevent the penetration of a potentially explosive atmosphere.
①
in the shaft. Correct the position.
80
90
100
112
M1
M10
M12 M12
0
180
210
1/2"
1/2"
75
75
4.5 Mounting the motor
②
. It is not necessary
132
160
180
200
M12
M16 M16 M16 M16 M16
250
280
320
1/2"
1/2"
5/8"
75
75
150
Installing
225
250
360
5/8"
150
37
Advertisement
Table of Contents
