Table of Contents
Advertisement
To install a spark plug:
(1) Clean the gasket surface.
(2) Wipe any dirt from the threads of the
spark plug.
(3) Install the spark plug, and then tighten it
to the specified torque.
Spark plug tightening torque:
12.5 Nm (9.2 ft-lb) (1.27 kgf-m)
(4) Install the spark plug cap.
NOTE:
Wipe off any water on the spark plug or in-
G
side the spark plug cap before installing the
cap. Push the spark plug cap down until it is
securely installed.
If a torque wrench is not available when you
G
are installing a spark plug, a good estimate
of the correct torque is 1/4 turn to 1/2 turn
past finger tight using the spark plug
wrench included in the tool kit. Have the
spark plug adjusted to the correct torque
with a torque wrench as soon as possible.
EWJ00350
WARNING
Be careful not to damage the insulator
when removing or installing a spark plug.
A damaged insulator could allow sparks to
escape, which could result in a fire or ex-
plosion.
(5) Install the seat.
EJU34421
Lubrication points
To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.
Recommended water-resistant grease:
Yamaha Marine Grease/Yamaha
Grease A
Maintenance and care
Throttle cable (handlebar end)
G
Loosen the adjuster and disconnect the
outer cable from the bracket. Spray a rust
inhibitor into the outer cable. Connect the
outer cable, and then adjust the throttle ca-
ble free play. (See page 75 for adjustment
procedures.)
1 Adjuster
Steering cable (handlebar end)
G
Steering cable (jet thrust nozzle end)
G
Jet thrust nozzle pivot shaft
G
76
Advertisement
Table of Contents
