Lubrication Points - Yamaha 2009 Wave Runner Operator's Manual

Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
To install a spark plug:
(1) Clean the gasket surface.
(2) Wipe any dirt from the threads of the
spark plug.
(3) Install the spark plug, and then tighten it
to the specified torque.
Spark plug tightening torque:
12.5 Nm (1.27 kgf-m, 9.2 ft-lb)
(4) Wipe off any water on the spark plug or
inside the spark plug cap, and then install
the cap. Push the spark plug cap down
until it is securely installed.
TIP:
If a torque wrench is not available when you
are installing a spark plug, a good estimate of
the correct torque is 1/4 turn to 1/2 turn past
finger tight using the spark plug wrench in-
cluded in the tool kit. Have the spark plug ad-
justed to the correct torque with a torque
wrench as soon as possible.
(5) Install the seat.
EJU34422

Lubrication points

To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.
Recommended water-resistant grease:
Yamaha Marine Grease/Yamaha
Grease A
Throttle cable (handlebar end)
G
Loosen the adjuster and disconnect the
outer cable from the bracket. Spray a rust
inhibitor into the outer cable. Connect the
outer cable, and then adjust the throttle ca-
Maintenance and care
ble free play. (See page 70 for adjustment
procedures.)
1 Adjuster
Steering cable (handlebar end)
G
Steering cable (jet thrust nozzle end)
G
72