Save; Sleep; Diagnostics And Identification Commands; Info - Javad HPT401BT User Manual

Command Line Interface

Diagnostics and Identification Commands

4.4. SAVE

The SAVE command is intended to store the unit's currently used configuration into the User
Configuration file. The configuration stored in the User Configuration file is activated by automatically
after unit's reboot.

4.5. SLEEP

The SLEEP command determines the sleep mode parameters. The sleeping AW400Tx can be activated
by real-time CLK, DTR/RTS lines, and command received through TTL inputs. The user can select one,
two, or all three conditions.
SLEEP [Parameter Name] [Parameters List] [/?]
Parameter Name
CLK
HW
TTL
GTS
5. Diagnostics and Identification Commands

5.1. INFO

The INFO command is used to retrieve the Radio ID along with its Hardware version, the loaded real-
time software version/revision and BootLoader's version/revision.
INFO [Parameter Name] [Parameters List] [/?]
Parameter Name
ID
SN
HW
SW
BL
The INFO command without Parameter Name indicates all values:
26
0 – Do not activate by internal real-time clock
(1 – 255) – Activate by internal real-time clock after 100 to 25500 msec of sleeping
0 – Do not activate through DTR/RTS lines
1 – Activate through DTR/RTS lines
0 – Do not activate by external sense lines
1 – Activate by external sense lines
0 – Disable Sleep mode (default)
(1 – 255) – Go to sleep mode if there is no activity in 10 to 2550 msec
Product ID
Six bytes Serial Number (SN)
1.0 – hardware version in numeric "Major.Minor" format
Ver. 1.0 Rev. A – displays software's version in numeric "Major.Minor" format and
revision in numeric format (range from 01 to 99) for engineering releases and alphabetic
format (A to Z) for manufacturing releases
Ver. 1.0 Rev. A – displays BootLoader's version in numeric "Major.Minor"format and
revision in numeric format (range from 01 to 99) for engineering releases and alphabetic
format (A to Z) for manufacturing releases
Parameter List
Parameter List
www.javad.com