Installation - Jobsite IR-CB2 Installation & User Manual

INSTALLATION

1. Select an appropriate location for the IR-CB2
2. Run all the necessary wiring to the IR-CB2. Label
the wires for future reference.
3. Plug the supplied 12V DC power supply into the un-
switched AC outlet.
4. Plug the 12V DC power supply connector into the
IR-CB2 socket marked POWER.
5. After verifying that the AC outlet works, unplug the
power supply connector.
6. Strip 1/4" of insulation from the end of each CAT5 wire.
7. Locate the Snap and Lock Connectors and remove
them if they are plugged in.
8. Use a small flathead screwdriver or your thumb to
raise the locking tabs, exposing the holes on the
connectors.
4
9. Insert each wire into the appropriate hole and
snap down the locking tabs.
10. Insert the smooth side of the connector plug into
the smooth side of the IR-CB2 socket.
11. Connect the emitters to the emitter outputs.
12. Plug the 12V DC power supply connector into the
IR-CB2 socket marked POWER.
See installation diagram.
Power Status
You can send a Power Status signal to all JobSite
IR Receivers by connecting a 12V DC power supply
from the switched AC power outlet of the
preamp/receiver to the status input jack of your
IR-CB2. Any 12V DC power supply with a minimum of
100mA current capacity can be used.