Package Contents; Preparing For Installation; Installation - Jobsite IR-CB4 Installation & User Manual

Four zone ir connecting blocks, for routing infrared commands from four ir receivers to eight sources

Hide thumbs Also See for IR-CB4:

Table of Contents

PACKAGE CONTENTS

IR-CB4 x 1

Snap and Lock Connectors x 5

In-line power supply x 1

Self-adhesive rubber feet x 4

The IR Receiver cables, Emitter cables and the 12V

DC power supply cable must all reach the proposed

location of the IR-CB4 connecting block. Mark the

cables with Wire labels, describing where the cables

originate from, rather than where they will terminate.

Locate a local un-switched AC outlet to be used to

power the IR-CB4 power supply.

Tools Required

1/8" Slotted screwdriver

Wire stripper

Wire labels

1. Select an appropriate location for the IR-CB4.

2. Run all the necessary wiring to the IR-CB4. Label

the wires for future reference.

3. Plug the supplied 12V DC power supply into the un-

switched AC outlet.

4. Plug the 12V DC power supply connector into the

IR-CB4 socket marked POWER.

5. After verifying that the AC outlet works, unplug the

power supply connector.

6. Strip 1/4" of insulation from the end of each

CAT5 wire.

Table of Contents