Page of 4

Jobsite IR-CB4 Datasheet

Four zone ir connecting blocks, for routing infrared commands from four ir receivers to eight sources.
Hide thumbs
   

Advertisement

DATA SHEET
For Routing Infrared Commands
From Four IR Receivers
to Eight Sources
IR-CB4
FOUR ZONE IR CONNECTING BLOCK

Advertisement

   Also See for Jobsite IR-CB4

   Related Manuals for Jobsite IR-CB4

   Summary of Contents for Jobsite IR-CB4

  • Page 1

    DATA SHEET For Routing Infrared Commands From Four IR Receivers to Eight Sources IR-CB4 FOUR ZONE IR CONNECTING BLOCK...

  • Page 2

    • Wings allow for either vertical of horizontal mounting SPECIFICATIONS • IR System: Works with all JobSite IR receivers, single and dual IR emitters • Connections: 4 receiver inputs, 8 emitter outputs • Home runs required from each IR receiver WIRING REQUIREMENTS: •...

  • Page 3

    PREPARING FOR INSTALLATION: The IR Receiver cables, Emitter cables and the 12V DC power supply cable must all reach the proposed location of the IR-CB4 connecting block. Mark the cables with Wire labels, describing where the cables originate from, rather than where they will terminate.

Comments to this Manuals

Symbols: 0
Latest comments: