Table of Contents
Advertisement
1. 12V DC Jack – Provides 12 volt DC power to
IR-CB1 via a regulated power supply.
2. IR Emitter Outputs – 3.5mm jacks provide output
for either single or dual low-level emitters.
3. 3-30V AC/DC Status – 3.5mm jack provides system
status to sensors/ keypads via a 12Volt power
supply attached to a switched outlet on the system
receiver or a 12V trigger output.
4. Status/IR Confirmation LED – This LED
performs two functions: (1) it provides a
visible indication of system status via a green LED
and (2) confirms the reception of IR data via a
blinking blue LED.
5. Sensor Input – Removable quick connect
sensor plug for connection of IR receivers.
PACKAGE CONTENTS
I
IR-CB1 x 1
I
Snap and Lock Connectors x 1
I
In-line Power Supply x 1
I
Self-Adhesive Rubber Feet x 4
PREPARING FOR INSTALLATION
The IR Receiver cables, Emitter cables and the 12V
DC power supply cable must all reach the proposed
location of the IR-CB1 connecting block. Mark the
cables with Wire labels, describing where the
cables originate from, rather than where they will
terminate. Locate a local un-switched AC outlet to
be used to power the IR-CB1 power supply.
Tools Required
I
1/8" Slotted screwdriver
I
Wire labels
I
Wire stripper
3
Advertisement
Table of Contents
