Switching Off The Water Softening System; Regeneration Of The Water Softening System - Siemens SN97T800CE User Manual

Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press ⁠ .
1.
To open the basic settings, press
2.
for approx. 3 seconds.
Press repeatedly until the display
3.
shows "Water hardness".
Press or
4.
display shows 0 - 8.
To save the settings, press
5.
approx. 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
repeatedly until the
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional run time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water softening
system after x rinse cycles
Additional run time in minutes
Additional water consumption in
litres
Additional power consumption in
kWh
The consumption values specified
are laboratory measurements determ-
for
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
16 - 20°E.
Water softening system en
6
7
5
0.05
29