Switching Off The Water Softening System; Rinse Aid System; Rinse Aid - Siemens SN27ZI00VI Information For Use

Place the lid back on the dis-
4.
penser and turn to close.
10.4 Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance,
only switch off the water softening
system in the following cases:
¡ The water hardness is max. 26 °E
and you are using a combined de-
tergent with salt replacement sub-
stances. According to the manu-
facturers, combined detergents
with salt replacement substances
can generally only be used up to a
water hardness of 26 °E without
adding special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press ⁠ .
1.
To open the basic settings, press
2.
for 3 seconds.
a The display shows H:xx.
a The display shows
Press or
3.
display shows H:00.
To save the settings, press
4.
for 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
⁠ .
repeatedly until the
11 Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
⁠ .
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Rinse aid system en
and lift
2
1
max
27