Table of Contents
Advertisement
en Troubleshooting
Fault
Water marks on plastic
parts.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
54
Cause
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
White coating is deposited in
the appliance interior.
Special salt dispenser is not
screwed tight.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62 °E
(8,9 mmol/l).
3in1/organic/eco detergent
is not effective enough.
Too little detergent is being
used.
Washing programme selec-
ted too weak.
Troubleshooting
Select a more intensive pro-
▶
gramme.
→ "Programmes", Page 19
Position tableware at an angle.
▶
→ "Arrange tableware", Page 34
Use rinse aid.
▶
→ "Rinse aid", Page 30
Set the water softening system
▶
higher.
Change your "detergent"
▶
→ Page 31.
Clean the appliance mechanically.
▶
Set the water softening system cor-
1.
rectly.
In most cases you will need to in-
crease the setting.
Change your detergent if required.
2.
Screw the special salt dispenser
▶
tight.
Change your "detergent"
▶
→ Page 31.
Clean the appliance mechanically.
▶
Set the Water softening system to
▶
the water hardness or add special
salt.
Set the Water softening system to
▶
the water hardness and use separ-
ate detergents (proprietary deter-
gent, special salt, rinse aid).
Increase the amount of detergent
▶
used or change "Detergent "
→ Page 31.
Select a more intensive washing
▶
programme.
→ "Programmes", Page 19
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Advertisement
Table of Contents
