Switching Off Water Softening System; Regeneration Of The Water Softening System - Siemens SC76M542EU Information For Use

Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
11.4 Switching off water
softening system
Note
To avoid damage to the appliance,
only switch off the water softening
system in the following cases:
The water hardness is max. 26 °E
¡
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
The water hardness is 0 - 8 °E.
¡
You do not need to use special
salt.
1
Depending on the appliance specifications
1.
2.
3.
a
4.
a
5.
a
11.5 Regeneration of the wa-
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Water softening system en
Press ⁠ .
Hold programme button A and
press repeatedly until the dis-
play shows H:xx.
Release programme button A and
⁠ .
Programme button A flashes and
the display shows H:04.
Press programme button C re-
peatedly until the display shows
H:00.
Press to save the setting.
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
ter softening system
25