Table of Contents
Advertisement
Wiring
1. Adjust the length and position of each wire so they reach the proper terminal on the connector block
2. Strip away 0.25 inch of insulation from each wire. Do not allow adjacent wires to short together when
3. Match and connect the unit wires to the proper terminals on the connector block.
4. Push excess wire back into the wall and seal the drilled hole to prevent air leaks.
5. Attach the unit to the sub-base.
6. Turn on power to the cooling/heating equipment.
BAS-SVX078E-EN
Note: Ensure all wires extend through the hole in the sub-base as shown below.
of the sub-base.
connected.
Installation and Wiring
11
Hide quick links:
Advertisement
Table of Contents
