Korg Karma Parameter Manual page 276

4 The notched side of the EXB-PCM is PIN 1. Install the
EXB-PCM with its PIN 1 side aligned with the PIN 1
mark ( ) of the slot.
EXB–PCM
Notch
1PIN
Locking hole
rear side of EXB-PCM
5 At a slant, press the EXB-PCM firmly all the way into the
slot, and raise it to the vertical position until the catches
of the slot click into the locking holes of the EXB-PCM.
When doing so, pressing the catches of the slot apart to
the left and right will help the board go in smoothly.
1. Firmly press in at an angle.
2. Tilt up vertically.
Catch
6 Close the EXB-PCM cover, and set the [LOCK/
UNLOCK] switch to the LOCK position.
The cover will not close if the [LOCK/UNLOCK]
switch is in the LOCK position. Move it to the
UNLOCK position and close the cover before moving it
to the LOCK position.
7 When all steps have been completed, turn on the power
and make sure that the EXB-PCM has been installed cor-
rectly. ( p.265 "Checking after installation")
266
Catches
slot2
72PIN
Locking hole
EXB-PCM
Front
Removing an EXB-PCM
• Spread the catches of the slot apart to the left and right,
and (after removing the stoppers from the catches) tilt
the EXB-PCM and pull it out.
If you wish to remove the rear EXB-PCM board, you must
first remove the forward EXB-PCM.
When you spread the catches of the slot apart, the EXB-
PCM may pop out vigorously and fall into an opening
(inside the instrument). Please be careful.
Catch
EXB-PCM
Front