Korg Karma Parameter Manual page 254

CC#76: LFO1 speed
Corresponds to "LFO 1 Frequency" (PROG 5.3: Ed–LFOs,
OSC1/2, LFO1 page).
CC#77: LFO1 depth (pitch LFO1 intensity)
Corresponds to "Pitch LFO1 Intensity" (PROG 3.1: Ed–
Pitch, OSC1LFO page).
CC#78: LFO1 delay
Corresponds to "LFO1 Delay" (PROG 5.3: Ed–LFOs, OSC1/
2, LFO1 page).
CC#79: Filter EG intensity
Corresponds to "Filter EG Intensity to A, B" (PROG 4.1/2:
Ed–Filter1/2, Mod.1 page).
Different parameters are controlled for the bank F programs
that are available when the separately sold EXB-MOSS
option is installed. ( "EXB-MOSS owner's manual" & p.269
"EXB-MOSS option")
*6 Controlled on the global MIDI channel.
*7 If you assign a CC# to a KARMA Realtime Controls
knob or switch and operate it, the specified CC# will be
transmitted, and at the same time the KARMA music
workstation will also be controlled. When this message
is received, the result will be the same as if the actual
knob or switch had been operated.
Assignments of a CC# to each knob or key can be made
in GLOBAL mode 6.1–2(2): KARMA 1 (2) pages. Nor-
mally you will leave this Off. Make these settings only
when you need to assign MIDI control change messages;
for example when you wish to record KARMA Realtime
Controls knob or key operations into the internal
sequencer or an external MIDI sequencer, or when you
wish to control the KARMA function from an external
MIDI device.
Although it is possible to set each knob and key to any
MIDI control change message CC#00–95, you should
normally use the utility menu command "Reset KARMA
Ctrls Assign," and select "Default Setting." ( p.146)
This table shows only the operations for the "Default Set-
ting." The "Default Setting" is the recommended CC# for
use by each of these controllers. Normally you should
assign these CC#'s for use.
*8 Corresponds to the operation of the [VALUE] slider as a
controller in Program or Combination 1.1: Play when
"Program Select" or "Combi Select" is the edit cell.
244