Tyco Electronics Raychem Interconnect AA-400 Mark IV Operation Manual
  1. Manuals
  2. Brands
  3. Tyco Electronics Manuals
  4. Power Tool
  5. Raychem Interconnect AA-400 Mark IV
  6. Operation manual

Tyco Electronics Raychem Interconnect AA-400 Mark IV Operation Manual

Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Raychem Interconnect AA-400 Mark IV and is the answer not in the manual?

Questions and answers

Related Manuals for Tyco Electronics Raychem Interconnect AA-400 Mark IV

Summary of Contents for Tyco Electronics Raychem Interconnect AA-400 Mark IV

  • Page 2: Table Of Contents

    Contents Section Title Page General Description Safety Installation Operation Accessories and Replacement Parts Technical Specifications...

  • Page 3: General Description

    SECTION 1 GENERAL DESCRIPTION Heat Gun The CE 240-Vac AA-400 Mark IV The SolderSleeve Reflector tip is used The needle-point tip is used for micro- super heater is a compressed-air for installing SolderSleeve shield miniature connectors. This tip comes heating tool— terminators and wire splice sleeves.
  • Page 4 SAFETY (continued) Safety Precautions and The AA-400 Mark IV equipment must Emergency Shutoff General Warnings be connected to an earthed power The AA-400 Mark IV is not equipped • The heat gun must be placed on its supply. with stand when not in use. It should not be hard-wired to a mains an emergency shutoff system.

  • Page 5: Installation

    SECTION 3 INSTALLATION Unpacking The power cable that comes with the Remove any packing and inspect the WARNING AA-400 Mark IV is not fitted with an AA-400 Mark IV for damage. Check IEC plug. It is the responsibility of the that all items have been supplied.

  • Page 6: Operation

    SECTION 4 OPERATION CAUTION WARNING Step 7 Never leave the 240-Vac AA-400 Mark If it is necessary to use a variable To turn the AA-400 Mark IV off, follow IV super heater running unattended. transformer to correct for a low-voltage Step 5 of the Installation Procedure.

  • Page 7: Accessories And Replacement Parts

    SECTION 5 ACCESSORIES AND REPLACEMENT PARTS Accessories and Replacement Parts Part Number SolderSleeve Reflector 979646 Needle-Point Tip 979647 Boot and Tubing Tip 979691 Mini SolderSleeve Reflector 979663 Low-Flow-Point Tip 979672 Stand 979649 Input Air Filter 979673 SECTION 6 TECHNICAL SPECIFICATIONS Power supply 240 Vac, 2A, 50–60 Hz Power consumption...
  • Page 8 Buyer—to processing or materials that do not affect compliance with any applicable specification. SolderSleeve, SolderTact, and Thermofit are trademarks of Tyco Electronics International Ltd. Raychem Interconnect Division A Division of Tyco Electronics International Ltd.

Table of Contents