Configuring The Hardware - Noraxon ultium EMG Quick Start Manual

Insole Smart Lead Quick Start Guide

4 Configuring the Hardware

Step 1
Open MR3, typically listed under Noraxon ->
MR3
Click on the Hardware Setup button in the
upper right-hand corner.
Step 2
Select the Ultium icon, within the 'New Device'
column, and click on the Insert button.
Note: Make sure the Receiver is connected to
the USB port of the computer via USB Cable
(CBL2).
Step 3
The Ultium Settings dialog will appear as shown.
Within the 'Settings Tab', select the desired
collection Sampling Rate.
If using MyoSync, check the Use Noraxon
MyoSync checkbox (see the Ultium EMG User
Manual for more information).
Select a RF Network from the RF Network list. In
most cases the default "1" will work. However, if
using multiple Ultium systems they must be
placed on separate networks.
Note: Firmware updates for the Receiver will be
indicated here, if they are required.
(Rev A)
6