Noraxon ultium EMG Quick Start Manual page 7

Insole Smart Lead Quick Start Guide
Step 5
Click the Sensors Tab.
Place all Ultium Sensors into the chargers and
attach the chargers to the Ultium Receiver.
Attach the Insole Smart Leads to the Ultium
sensor.
Click Detect Sensors in Charger to load all
serial numbers into the MR3 software.
Step 6
After detection is complete, click Yes to replace
all existing sensor serial numbers associated
with this device.
Step 7
Select the Insole Mode
Click on OK (in the bottom of the dialog box)
when done.
Note: Sensor serial numbers appear in the
order that they are placed in the charging doc,
starting at the end with the LEDs (opposite of
the charging port).
(Rev A)
7