Web Interface - Dashboard - Microsemi SyncServer S600 User Manual

Web Interface
The SyncServer S6x0 also allows the user to access information via the LAN1
Ethernet port using HTTPS protocol. To use the SyncServer S6x0 web interface,
enter the IP address for Ethernet port 1 into a web browser. Enter your user name
and password for the SyncServer S6x0 when prompted.
Dashboard View
See Figure 1-19
Figure 1-19. Web Interface - Dashboard
Command Line Interface (CLI)
The Command Line Interface can be used to control specific function of the
SyncServer S6x0 from a terminal connected to the EIA-232 serial port or the
Ethernet LAN1 port. Refer to
details.
Note: Before you can communicate with the SyncServer S6x0
through an Ethernet connection, you must first configure the Ethernet
port using the serial connection or front panel (see
Ethernet Ports
098-00720-000 Revision B – April, 2016
for an example of the dashboard status screen that will appear.
Chapter 5, Command Line Interface (CLI)
, on page 142).
Chapter 1 Overview
Configuration Management
for further
Provisioning the
SyncServer 600 Series User's Guide 35