Table of Contents
Advertisement
Chapter 1. Safety Precautions
Before using the product
To use the product safely and effectively, please read the contents of this manual thoroughly before use.
Please keep to the safety precaution, for it is to prevent accidents and potential danger from occurring.
Safety precaution is classified into 'Warning' and 'Caution' and their meanings are as follows. Also the
indicated illustrations on the product and in the manual have the following meanings.
Violating the instruction may result in serious personal injury or death.
Violating the instruction may result in slight personal injury or product damage.
Be cautious, for danger may be present.
Be cautious, for there is a possibility of an electric shock.
General Precautions
Do not press the screen with a hard or sharp object (awl, screwdriver, pen) with too strong a force.
It may cause malfunction of touch due to damage of the front sheet.
Do not use or store in an environment with high vibration.
Do not allow foreign objects such as water, liquids, or metal powders to enter the product. This may cause
breakage or electric shock.
Do not allow foreign objects such as water, liquids, or metal powders to enter into the front(screen)
protective sheet. The screen may be invisible or may cause a malfunction of the touch.
Use the radio or mobile phone at least 30cm away from the main unit.
Two or fewer bright spots may appear on the LCD screen, and certain areas may appear brighter, but this
is not a defect in LCD characteristics.
Do not store or operate in direct sunlight. Direct sunlight can change the properties of the LCD.
Design Precautions
Do not install the location which exceeds allowed temperature. Product can be damaged or shorten the life.
Especially Install environment as below should be avoided.
As the malfunction & incorrect result of Products could damage the stability of the entire systems and
human body, you must install damage preventing interlock circuit such as emergency stop, Protective
circuits, positioning upper and lower limit switch and interlock for forward/reverse operation.
When computer or other controllers communicate and exchange data with products or change operation mode of
products, set up protective sequence program in PC or Controller for protecting system from communication error.
The output signal or communication lines should be separated from the power line or high tension wire.
They should be installed 100mm (3.94 inch) or more from each other.
Normal environmental conditions
Indoor use.
Altitude up to 2000m.
Wiring Precautions
Be sure the wiring is done correctly by checking the product's rated voltage and the terminal
M
I Corporation
2
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
TOP-PCVIEW Hardware Manual
4 / 33
Advertisement
Table of Contents
