Table of Contents
Advertisement
Chapter 7. Wiring
7.1 Power wiring
(1) The Power cable should have the following specification
Power Cable Specification
FG Cable Specification
Conductor type
Bolt tightening force
Conductor length
Temperature rating of the field installed conductors
(2) The Power terminal should have the following specification.
(3) Wiring of power is as follows.
7.2 Ground wiring
(1) The Product has enough anti-noise measure, so except that there are many noises specially, the ground is
not needed. When doing ground, please refer to the followings.
(2) The ground should be the exclusive ground. The ground should be type 3 ground (ground resistor is less
than 100Ω).
(3) When not doing the exclusive ground, do common ground like figure B).
(4) Use the cable more than 4mm
M
I Corporation
2
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
B
L
1.8~2.0
22~18
AC Power Type
Exclusive ground
2
. Put the point of the ground near TOP PC and shorten ground line.
Simple or Stranded wire(Use Copper Conductors only)
F
E
D
12~14
5
3.3~3.8
DC Power Type
Common ground
TOP-PCVIEW Hardware Manual
0.75~2.5mm
(18~12AWG)
2
Over 4mm
(11AWG)
2
≥ 0.5N.m
65 ℃ Only
d
2~2.5
Common ground
19 / 33
Advertisement
Table of Contents
